Answer:
Q:
What characteristic is shared by sunspots, solar flares, and coronal mass ejections? Select the two correct responses.
A:
They tend to occur during active periods of the solar cycle. & They are caused by outward fluctuations of the sun's magnetic field.
Q:Drag each item to the correct location.
A: sunspot: cooler area on suns surface where the magnettic field emerges
solar flare: intense burst of radiation coming from the rapid release of magnetic energy
coronal mass ejection: large bubble of plasma from the rapid release of magnetic energy
Q: Which is the cause of the sun's magnetic properties?
A: uneven churning of plasma
Explanation:
took quick check
good luck yall
The uneven churning of plasma is the cause of the sun's magnetic properties, therefore the correct answer is option B.
What is a magnetic field?A magnetic field could be understood as an area around a magnet, magnetic material, or an electric charge in which magnetic force is exerted.
For a simple bar magnet, N-pole and S-pole are the points on a magnet that have the strongest magnetic field. The magnetic field originates from the north pole and terminates in the south pole of a magnet.
The positively charged ions and negatively charged electrons that make up the plasma of the Sun move around a lot due to its high temperatures. Multiple intricate magnetic fields that twist and turn are produced by the moving plasma. A magnetic field is produced by the extremely hot plasma that escapes from the Sun as the solar wind.
Thus, The sun's magnetic properties are caused by uneven plasma churning, so option B is the correct answer.
Learn more about the magnetic fields from here
brainly.com/question/23096032
#SPJ2
5.
1
Shown above is a wire that is carrying current in a magnetic field. The magnetic field
is coming out the plane of the page.
What is the direction of deflection of the wire?
A) Upwards
B) Downwards
C) To the left
D) To the right
Answer:
The direction of defliection of the site to the left I think ..
which of the following are fundamental unit ?
I.candela
II.ampere
III.mole
IV.all of these
Answer:
all of these very easy questions
what is the name of the chart that contain elements?
Answer:
Element Chart
Explanation:
It is a chart that provides many different elements.
The elevators in the John Hancock building in Chicago move 783 ft in 33 s. What is this speed in miles per hour?
Answer:
16.18 mph
Explanation:
the speed of elevators =
(783×3600)/(33×5280) =
2,818,800/174,240 = 16.18 mph
Record the length of the line shown in centimeters.
7.30
7.12
7.3
7.28
Please help will be marked most brainlist !!
Zooming I. On the image the red line is just short of the 3rd line past the 7 so it is not 7.3 but just a little under.
Answer: 7.28
what is the density of a 75 g block of wood measuring 12 cm x 8cm x 9cm
Answer:
density is equal to mass divided by volume (m/v)
volume: 12×8×9=864cm³
75÷864=0.09
Answer: 0.09g/cm³
the density of the metal is 8.9g/cm³.what does it mean. What is the importance of the value
Density of the metal is 8.9g/cm^3
It means per 1cm^3 Volume there is 8.9g of Mass occupied .Density:-
[tex]\boxed{\sf Density=\dfrac{Mass}{Volume}}[/tex]
SI unit:-
SI unit of density is kg/m^3
CGS unitCGS unit of density is g/cm^3
Can someone tell me which is which on what i put i dont know what i should put
what is pulley? How does it help in lifting weight?
Hey there!
A pulley is a "system" that has a rope attached to carry heavy materials off the ground. Once you pull the rope, the heavy item will be carried.
Hope this helps!
Have a great day!
How can radio waves & microwaves communicate over similar distances?
Round 0.010229 to four sig figs
It would be 0.01023.
0.010229 has 5 sig. fig.'s (leading zeros do not count)
So rounding to 4 sig. fig.'s is just a matter of rounding off the last digit, which leaves you with 0.01023.
Slove these problem physics
Answer:
element name = neon
no of proton = 10
no. if neutron = 9
atomic no. = 10
atomic weight = 20.17179u
it lies in group 18 and period 2
it is nonmetal because it is a noble gas .
hope this helped you ☺️
in the Newton's Third Law of Motion state three characteristics
Answer:
Newton's third law: If an object A exerts a force on object B, then object B must exert a force of equal magnitude and opposite direction back on object A. This law represents a certain symmetry in nature: forces always occur in pairs, and one body cannot exert a force on another without experiencing a force itself.
Which statement is true?
A. When a gas condenses to a liquid, it absorbs energy.
B. When water boils, it releases energy.
C. When ice melts, it absorbs energy.
D. When water freezes, it absorbs energy.
Explanation:
The correct answer is option B
Answer:
C. When ice melts, it absorbs energy.
Explanation:
When ice melts, it is getting hotter by absorbing energy and changes from a solid to a liquid. This is an endothermic reaction.
Please help ???????.......
Answer:
300,000=3×10^3
.000012=1.2×10^-6
a radioactive element has a half-life of 30 days. calculate the mass of the element that remains after 20 days if 100g of the element decays. Also, calculate the decay constant.
Explanation:
the answer is in the image above
Two trucks left the warehouse at the same time and drove in
the same direction along a straight road. One truck drove at 68
km/h while the other drove at 57 km/h. Find theirs distance
apart after2 hours.
10. Numerical problems:
b. A stone is thrown vertically upwards with an initial velocity of 20 m/sec.find the maximum height it reaches and the time taken by it to reach the height. (g = 10 m/s2).
c. A car is moving at a rate of 72 km/hr. How far does the car move when it stops after 4 seconds?
d. A bus starts from rest. If the acceleration is 2 m/s2, find
1. the distance travelled.
2. the velocity after 2 seconds.
e. A stone is thrown vertically upward with the velocity of 25 m/s. How longo it take to reach the maximum height? Also calculate the height.
with process please
Answer:
a)20 m,2s
Explanation:
Given
Initial velocity=20 m /sec
g=10 m/s square
v =0m/s
h =?
t =?
now,
v = U +gt
=v=20 +10t
Or,10t=20
Or,t=20
10
therfore ,2 s.
Again,
h=ut -1 gt square
2
Or, h=20×2-1×10(2)square (multiply and cut )2×5 =10
; 2
Or,40-5×4
therefore , 20m
Worth 10 points! I will give brainliest!! Please help!!! See picture!
Answer:
The last option
Explanation:
A train is moving with the velocity of 10m/s . It attains an acceleration of 4m/s after 5 sec . find the distance covered by train at that time.
What's Centripetal force................
Answer:
a force that acts on a body moving in a circular path and is directed towards the centre around which the body is moving.
Answer:
A centripetal force is a force that makes a body follow a curved path. Its direction is always orthogonal to the motion of the body and towards the fixed point of the instantaneous center of curvature of the path.
If Bert the Bat travels eastward at 40 mph with a tailwind of 6 mph, what is his actual speed?
Answer:
36 mph.
Explanation:
Now Albert here is using the wind to his advantage but if say there was no wind then he would not have the 6 mph behind him so we subtract 6 from 40 to get 36. hope this helps :)
A shift inward of the production possibilities curve signifies that _
A. The demand for the products has increased, so the supply will increase
B. The available resources have increased, so potential production levels will increase
C. The available production resources have decreased, so potential production levels will decrease
D. The demand for the products has decreased so, the supply will decrease
Answer:
c
Explanation:
A shift inward of the production possibilities curve signifies that: C. The available production resources have decreased, so potential production levels will decrease.
A production possibilities curve (PPC) is also referred to as production possibilities frontier (PPF) and it can be defined as a curve that illustrates the maximum (best) combinations of two (2) products which can be produce in an economy if they both depend on these two (2) main factors;
Fixed technology. Fixed resources.Basically, the production possibilities curve (PPC) illustrates the maximum combinations of goods that are available with fixed technology and resources.
Furthermore, an inward shift of the production possibilities curve (PPC) signifies that the available resources used for production have decreased, so potential production levels would also decrease.
Read more: https://brainly.com/question/17053992
tides occurs in oceans but not in lakes.why?
Answer:
Explanation:
Tides occur in the ocean but nit in lakes because an ocean is a free flowing body of water that can travel a large area of the globe while a lake or pond only covers a small area of the earth so it is not affected by gravity as violently and in turn, prevents the formation of tides.
seharitat -The distance of a panet from the earth is 2.5 x 10^7 km and the gravitational force between them them is 3.82 x 10^18 N. Mass of the planet and earth are equal, each being 5.98 x 10^24 Kg. Calculate the universal gravitation constant.
We know
[tex]\boxed{\sf F=G\dfrac{Mm}{r^2}}[/tex]
[tex]\\ \sf\longmapsto G=\dfrac{Fr^2}{Mm}[/tex]
[tex]\\ \sf\longmapsto G=\dfrac{3.82\times 10^{18}(2.5\times 10^7)^2}{(5.98\times 10^{24})^2}[/tex](M=m)
[tex]\\ \sf\longmapsto G=\dfrac{3.82\times 10^{18}(6.25\times 10^{14})}{35.7\times 10^{48}}[/tex]
[tex]\\ \sf\longmapsto G=\dfrac{23.87\times 10^{32}}{35.7\times 10^{48}}[/tex]
[tex]\\ \sf\longmapsto G=0.668\times10^{-16}[/tex]
[tex]\\ \sf\longmapsto G=6.68\times 10^{-15}[/tex]
14 km = m on conversions using a ladder method
eo *Write any two uses of good condutor of heat
any two uses of good conductor of heat are
aluminium, cooper, metal are good conductor of heat and they are used for making utensils.
gold, silver, are also good conductor of heat they are used for making jewelleries.
1 point
30. A ray passing through the centre of curvature of a concave mirror.
after reflection is reflected back along the same path. Which is the correct
figure for the above statement.
Explanation:
when the object is between the pole and focus
If a ball is rolling at a velocity of 1.5 m/s and has a momentum of 10.0 kg times m/s, what is the mass of the ball?
Answer:
Mass of the ball, M = 6.667 kg
Explanation:
Given data:
Momentum, Mo = 10.0 kgm/s
Velocity of the rolling ball, V = 1.5 m/s
Mass of the body, M = ?
Momentum, Mo = Mass, M x Velocity, V
10.0 kgm/s = M x 1.5 m/s
Divide each side by 1.5 m/s
M = 10.0 kgm/s / 1.5 m/s
M = (6⅔) kg
:. Mass of the ball, M = 6.667 kg
how do i solve this?
Answer:
hmmm i dont know....
Explanation:
i just wanted free point. TANKS YOU SIR!!
